Dryer vent cleaning
Whole-home duct cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Nikro Dryer Vent Cleaning in Fort Lauderdale: What to Know First
We provide independent Nikro dryer vent cleaning and repair in Fort Lauderdale, and most jobs are completed in a single visit. The honest price posture is simple: you’ll know the written cost before any work starts, and that figure does not move once our technician arrives. If you own a Nikro unit and the dryer is running hot or taking longer than it used to, call us at (754) 354-3644 and we’ll put a real number on the fix.
This page is for Fort Lauderdale homeowners who own Nikro equipment and want a vent cleaning crew that understands the brand well enough to do the job right the first time. Roy Castellanos and our technicians see Nikro units regularly across Broward County, from Victoria Park to Coral Ridge to the neighborhoods west of Federal Highway. You’ll get a straight answer about what your vent actually needs, not a sales pitch.
How Nikro Products Fail – and How We Fix Them
Nikro builds negative-air machines and professional cleaning equipment that commercial crews use, but the dryer vent systems attached to them still collect lint the same way every other system does. Here are the failure patterns we see most often on Nikro-branded setups in Fort Lauderdale homes:
- Blocked exhaust on Nikro negative-air dryer vent systems. Nikro’s portable negative-air machines depend on steady airflow to maintain suction. When the vent line behind the machine is packed with lint, the airflow drops and the entire cleaning run loses effectiveness. We snake the full vent run, clear the obstruction, and verify suction at the exterior termination point before we leave.
- Lint accumulation at transition elbows on Nikro duct runs. Fort Lauderdale homes built in the 1970s and 1980s often have dryer vents that make two or three sharp turns before exiting. Lint collects at every elbow, and on Nikro systems we’ve seen the first elbow after the machine carry the heaviest load. Our rotary brush reaches those bends, and we follow with a negative-air pass to pull the dislodged lint out rather than pushing it deeper.
- Crushed or kinked flex duct behind the dryer. The flexible transition hose behind any dryer, Nikro included, gets crushed when the machine is shoved back against the wall. Crushed duct restricts airflow, which means the dryer works harder, runs longer, and dumps more heat into an already-loaded vent line. We inspect that connection on every job and replace crushed flex with rigid or semi-rigid duct when the run allows.
- Bird or rodent intrusion at the exterior vent cap. Fort Lauderdale’s climate means birds nest year-round, not just in spring. We’ve pulled nests out of vent caps on every major brand, and Nikro setups are no exception. A blocked exterior cap makes the whole system work against itself. We clear the debris, check the damper, and install a bird guard if the homeowner wants one.
- Worn flex connectors that leak air around the seal. On older Nikro cleaning setups we see flex connectors that have dried out in the Florida heat and no longer seal tight. Air leaks at the connector reduce suction at the tool end, which means lint stays in the vent instead of leaving through the machine. We replace the connector with a proper-fitting part and then retest airflow to confirm the fix.
Styles & brands we work with
Our Nikro Dryer Vent Cleaning Process
Every job follows the same sequence, whether it’s a Nikro unit or any other brand we service. The discipline matters more than the brand label.
- 1
You call, a live person answers. We take your address, ask a few questions about the dryer’s behavior, and schedule a visit inside a written arrival window. No voicemail tennis, no callbacks at the end of the day.
- 2
We inspect before we touch. The technician checks the full vent run from the dryer to the exterior cap, measures airflow, and identifies what’s actually causing the problem. On Nikro systems, that means checking the machine’s filter, hose connections, and the vent run behind it.
- 3
You get a written price. The cost is on paper, itemized, before any cleaning work starts. If the inspection turns up a crushed flex line or a failed vent cap, we price that separately and you decide. Nothing gets added at the door.
- 4
We clean by the book. Rotary brush through the vent line, followed by negative-air extraction to collect the dislodged lint. The Nikro machine’s own filter gets checked and cleaned so the system operates the way it was designed to.
- 5
We test and verify. After the vent is clear, we run the dryer and measure airflow again. You see the difference in the numbers, not just in how the dryer sounds.
- 6
We leave the site clean. Drop cloths down, debris bagged and removed, the area around the dryer cleaner than when we arrived. The 365-Day Done Right Promise backs the work in writing for a full year.
See the difference
Before
After
Before
After
Before
AfterWhat Nikro Dryer Vent Cleaning Costs in Fort Lauderdale
Here are the price ranges we quote for Nikro dryer vent work in Fort Lauderdale. These are whole-system prices, not teaser numbers that grow once the van is parked in your driveway.
| Service | Typical Price Range |
|---|---|
| Standard dryer vent cleaning (single-story, vent run under 20 feet) | $150 – $250 |
| Dryer vent cleaning with complex multi-elbow run (common in older Fort Lauderdale homes) | $250 – $350 |
| Vent cap replacement (standard metal cap, installed) | $75 – $150 |
| Bird guard installation | $60 – $120 |
| Flex-to-rigid duct replacement (behind dryer, shorter runs) | $125 – $225 |
What moves the price: the length of the vent run, the number of elbows, roof access if your vent terminates there, and whether we’re replacing a failed component at the same time. Every quote starts with a written estimate and stays at that figure. Call (754) 354-3644 for an exact quote on your Nikro setup. Estimates are free, and we’ll tell you if the vent just needs a straightforward cleaning rather than anything more.
Why Fort Lauderdale Homeowners Call Hollis Air Duct Fort Lauderdale for Nikro Work
Roy Castellanos started in this trade at Los Angeles Trade-Technical College and has spent close to two decades working on HVAC and air duct systems across South Florida. He’s cleaned systems in homes a few blocks from Las Olas Boulevard and in commercial buildings near the Port Everglades corridor. He’ll also tell you straight when your Nikro vent doesn’t need anything beyond a basic cleaning. That’s the whole point of The Garrison Standard: written prices, a written 365-Day Done Right Promise, and no job left messy.
Our technicians are background-checked and uniformed. They carry professional-grade equipment from Rotobrush, Nikro, Abatement Technologies, and filtration brands like Honeywell, Aprilaire, and Guardsman. When a Nikro unit shares ductwork with an HVAC system from Lennox, Trane, or Carrier, we service those too, so one visit can cover the full system. Clean ducts move air. Everything else is just noise.
FAQs
We are an independent Nikro service provider and not authorized by Nikro, so any manufacturer warranty claim would go through Nikro directly. What we cover is our own work: every dryer vent cleaning and repair we perform carries the 365-Day Done Right Promise in writing. If something fails within that year, we return and make it right at no charge. Call (754) 354-3644 and we’ll walk you through what’s covered before any work starts.
Most Nikro dryer vent cleanings in Fort Lauderdale are done in a single visit that takes 60 to 90 minutes. We schedule inside a written arrival window, so you’re not waiting around all day. When you call, we’ll give you the soonest available slot and a firm price before the technician leaves the shop.
If the vent line is clear, the flex connection is intact, and the exterior cap still seals, repair is almost always the cheaper and quicker path. Replacement makes sense when the duct itself is crushed, rusted through, or so short that a reroute is the only way to get proper airflow. We’ll show you what we found during the inspection and let you decide from there, with a written price either way.
Cheaper quotes in this trade usually mean one of two things: a teaser price that grows once the technician is inside, or a crew that doesn’t carry the right equipment for a full negative-air clean. We price the whole system before we start, and the number doesn’t move. If you’ve got a quote from another company, we’ll tell you honestly whether it looks complete.
We verify with airflow readings before and after the cleaning, and we show you the numbers. On Nikro systems we also inspect the machine’s own filter and connections so you can see what we cleared. If you want, we’ll take before-and-after photos of the vent interior and the exterior cap.
Written by Roy Castellanos, Owner, Hollis Air Duct Fort Lauderdale at Hollis Air Duct Fort Lauderdale, serving Fort Lauderdale and nearby areas.